to ensure thatSlewing ringThe inventory is abundant, and some manufacturers buy more slewing bearings. If the slewing bearing is not used for a long time, if the slewing bearing is stored in a certain province, it will form corrosion for a long time, and the slewing bearing cannot be used normally. Today, the editor will specifically introduce how to store the slewing ring if it is not used for a long time. I look forward to some help to everyone after the specific introduction.
Specifications and issues for long-term storage of slewing bearings:
1. Warehouse temperature: The slewing bearing is coated with anti-rust agent in front of the original factory. If the temperature is too low or too high, it will form the anti-rust agent and mildew. The indoor temperature should be controlled at 0-25℃.
2. Warehouse ambient humidity: Too high ambient humidity will cause the slewing ring to rust, and the warehouse air humidity should be maintained at 45%-60%.
3. The natural environment of the warehouse: The slewing bearing is preferably stored separately. When it must be stored with other objects, the other objects that coexist are not only organic chemical objects such as acids, alkalis, and salts. Place it off the pavement and avoid heating pipes.
4. Timing protection: According to the requirements of the product's anti-rust treatment, it will be protected every 10-12 six months. If it is found that the skeleton sealing package is corroded, the skeleton sealing package should be opened again to prevent other chemical substances from entering the interior and forming the corrosion of the slewing ring.
When the slewing bearing is not needed for a long time, it is necessary to carefully deploy the protection and maintenance to prevent the slewing bearing from rusting, eroding and other problems, which in turn endangers the service life and use of the product.
When the slewing bearing is installed, run the Aura check, it will not touch the server installation surface well, the radial backlash of the installation, the irreversible deformation, the negative gap of the support plate, roll back to the negative space condition , The turning body is difficult to run in the dovetail rail. Or the standard transmission gear toothing is not good, or there is dirt in the standard transmission gear.
Removal method: re-produce the installation plan of the processing server, make the installation plan meet the requirements, adjust the backlash of the standard transmission gear according to the regulations, pay attention to the large part of the transmission gear, and check to ensure that the standard transmission gear is free of dirt. Replace each open space with a slightly larger one.
The above is a simple and specific introduction to the slewing bearing if it is not used for a long time. I look forward to some help to you. If you have a variety of requirements for people's products, you are warmly welcome to contact them, and people will consider your requirements with service items!
